![]() In fact, you can’t “flip” the belt, but you can see the underside of the belt all the way around. After that, flip the belt over a bit to inspect the teeth.One or two small cracks in the outer layer of the belt are fine, but if it has too many cracks on its surface it can cause excessive wear.Firstly, you need to look at the outer surface of the belt to see if it has small cracks.Therefore it is necessary to change or inspect it regularly.įollowing are the simple steps you can take to inspect the timing belts: How To Check If Timing Belt Is Worn?ĭue to the continuous and massive power under which a timing belt works, it may get worn sometimes. ![]() Once this happens, the engine will start to stall and may get failure. These teeth will fall directly on the gear and this can lead to “jump a tooth” causing a loss of power to your vehicle. If these teeth ever start to fall out or become brittle, the timing belt will slip out of the gear. Timing belts typically have teeth on the inside surface to hold the gears in place as they are rotating various engine parts and components. Once you experience this symptom, immediately shut down the engine to prevent further damage. If this happens, the crankshaft will turn automatically and will not keep the sync with the movement of the camshaft.īecause of that, the pistons will come into contact with the valves as they open and eventually bend the valves or damage the pistons. This is the worst symptom that occurs due to the failure of the timing belt.
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |